Otherwise they all need to be configured on the default WireGuard group that OPNsense creates. Second, it automatically adds an IPv4 outbound NAT rule, which will allow the tunnel to access IPv4 IPs outside of the local network (if that is desired), without needing to manually add a ruleįinally, it allows separation of the firewall rules of each WireGuard instance (each wgX device). Otherwise you will need to define your own alias or at least manually specify the subnet(s) However, it is useful to implement, for several reasons:įirst, it generates an alias for the tunnel subnet(s) that can be used in firewall rules.
Set protocols static interface-route 192.168.5.This step is not strictly necessary in any circumstances for a road warrior setup. Set protocols ospf passive-interface-exclude ‘wg01’ Set policy route-map CONNECT rule 10 match interface ‘wg01’ Set policy route-map CONNECT rule 10 action ‘permit’ Set interfaces wireguard wg01 port ‘51820’ Set interfaces wireguard wg01 peer to-wg02 pubkey ‘xxxxxxxxxxxxxxxxxxxxxxx=’ Set interfaces wireguard wg01 peer to-wg02 allowed-ips ‘10.1.0.0/30’ Set interfaces wireguard wg01 peer to-wg02 allowed-ips ‘192.168.5.0/24’ Set interfaces wireguard wg01 ip ospf transmit-delay ‘1’ Set interfaces wireguard wg01 ip ospf retransmit-interval ‘5’ Set interfaces wireguard wg01 ip ospf priority ‘0’ Set interfaces wireguard wg01 ip ospf network ‘point-to-point’ Set interfaces wireguard wg01 ip ospf hello-interval ‘2’ Set interfaces wireguard wg01 ip ospf dead-interval ‘6’ Set interfaces wireguard wg01 ip ospf cost ‘10’ Set interfaces wireguard wg01 ip ospf bfd Endpoint A is behind NAT (Network Address Translation) and a firewall that allows only. Set interfaces wireguard wg01 ip ospf authentication plaintext-password ‘ospf’ Wireguard setup with MikroTik and your smartphone MikroTik 89. Set interfaces wireguard wg01 description ‘VPN-to-wg02’ Set interfaces wireguard wg01 address ‘10.1.0.1/30’ Please check the configuration and point me to the error: It did not help establish the neighborhood. I tried the point -to-point network option and tried the broadcast network option. On VyOS, no firewall rule is bound to the wireguard interface. On Mikrotik, all traffic through the Wireguard interface is completely open. And neighborly relations are not established. But it does not receive Hello in response. I have successfully established a connection through wireguard. The task is to connect another Mikrotik there.
I have a VyOS which is receiving multiple tunnels.
0 kommentar(er)
